Adjustable LS Swap Motor Mounts Pack of 2 Bracket Kit
✔️ Thick 6mm cold rolled steel build with black powder coat
These dual mounting brackets remove restrictive factory rubber posts during engine swaps. They realign the crankshaft inside classic square body frames for improved radiator gaps.
✅ Precision slotted holes allow custom tilt angles
✅ Compatible with all Gen III and IV Chevrolet LS motors
✅ Direct bolt on replacement for GM Vortec powerplants
✅ Delivers two inch front travel and half inch rear travel
✅ Maintains rigid support for high torque street builds
💡 Why choose slotted motor mounts over fixed brackets for a truck restoration?
Upgrading older pickups demands handy alignment solutions for tight chassis rails.
– Slide the assembly back or forward to match aftermarket transmission bellhousings cleanly
– Adjust the engine pitch to align crankshaft pulleys with accessory drive systems
– Lock components tight once you verify fluid levels and heater hose routing properly
✝️
Rezensionen
Es gibt noch keine Rezensionen.